Assembly Guide

ATROX Snake Barrier Assembly Guide

How to Assemble Your New ATROX Snake Barrier

SNAKE SEASON IS HERE

BUY NOW >>
snake barrier

STEP 1:
Cut the Screen Material for each Straight Section of your
Atrox Snake Barrier

  • Roll out Screen Material, measure distance for first Straight Section, then cut screen material to desired length of Straight Section (scissors or razor blade)
  • Repeat for each Straight Section!
Assembly guide for cutting screen

STEP 2:
Attach Screen Material to J-Frames for each straight section

  • Set J-Frames 5 foot apart (or less if desired)
    Note: if straight section is 33 feet long for example, distance between final J-Frame will be 3 feet to complete the section
  • Square Up the Screen Material on Top and Side of J-Frame (left to right or vice versa)
  • Pierce screen material with self-tapping screw (provided) and screw into pilot hole
    Each J-Frame has 7 pilot holes to receive a self tapping screw
  • Repeat the above steps for each straight section of your Atrox Snake Barrier
Attaching the screen of the snake barrier

STEP 3:
Attach J-Frame (with screen material attached)
to corresponding Base

  • Insert Quick Release pin(s) into Base block
  • Repeat for each straight section
Connect J Frame to Base

STEP 4:

Fold Down each J-Frame into the Functional Position (left to right or vice versa)

J-Frame

STEP 5:

Lay the Corner Cap over the Two J-Frames attached to Corner Base then insert Four Quick Release Pins into Corner Cap holes and then J-Frame holes on side (2 on each side)

Corner Cap

STEP 6:

Start in any corner from inside: Secure first Corner Base to ground (ground stakes or cement anchors) > move to next Base, pull screen taught and secure Base to ground.

STEP 7:

Secure Screen Material to the Ground/Surface between each secured Base.

A. Ground (Natural Surfaces): insert a ground stake every foot to secure the screen material to the ground; or use landscape pavers, gravel or other heavier materials to secure the screen material to the ground
B. Cement (Hard Surfaces): use a cement anchor, landscape pavers, or gravel or similar to secure the sceen material to the ground

 

Extend Straight Section Past 100 Feet (Screen Material Roll = 100 Feet)

Insert a Gate in any straight section if equipment or vehicles needs to enter snake safe zone

Adobe PDF

Download the above Assembly Guide